ABOUT THE ROCKIN’ S SNAFFLE
This bit was designed to decrease the discomfort at the corners of the horse’s mouth. The bit will not pinch. The extra 3 inch rings at each end of the mouthpiece float independently to disperse the pressure across the lip and cheek helping the bit to become more stable in the horse’s mouth allowing the horse to become more responsive to the rider’s cues. The rein attaches to the floating “D” ring outside the cheek rings. “Lifetime Guarantee” on material and workmanship. No returns on bits that have been opened and used, and are not defective. There are now three bit styles available, the 2-piece mouthpiece, which is large and therefore extremely gentle, and the 3-piece mouthpiece (dog bone), which applies pressure to the tongue and outside of the bars for better control and a brand new raised snaffle for horses with a shallow pallet or thick tongue (see below). For additional comfort, all bits are made of sweet iron. Click here to read about Mark’s experience with the Rockin’ S Snaffle or contact the designer, Mark Sulan, at www.rockinsqh.com or firstname.lastname@example.org for more information.
Raised Rockin’ S Snaffle Bit
We began using the original Rocking S Snaffle Bit in 2006. Almost immediately we were struck by the positive changes that occurred in most horses we tried it on. Horses that had previously been head tossers, bit chompers, or just “hard mouthed” suddenly became way more amenable and easier to work with.
Still, one problem the bit was unable to address was the same problem most traditional snaffle bits have. That is, it didn’t allow enough room in the mouth for those horses that had low pallets or thick tongues. For these horses, there are very few bits on the market that are of much use, or that they are comfortable in.
I had been having some success with these types of horses with a snaffle bit I had picked up years ago which had a relatively solid mouthpiece and a medium port for tongue relief. In mid-2007 I contacted Mark Sulan, the fellow that came up with the original design for the Rocking S Snaffle, and talked with him about the possibility of using his cheekpieces on a mouthpiece similar to the mouthpiece that had been helpful to the horses in question.
My original idea for the mouthpiece was for it to have a port for tongue relief for thick tongued horses, and for the port to lay back in the horse’s mouth so it wouldn’t interfere with horses with low pallets. This idea was kicked around for a while between Mark and I and a couple of other folks. A mouthpiece was designed but quickly discarded due to too many moving parts.
Eventually, a design was settled on, and prototypes of the bit were built. The bit was tried on a large number of horses, some with low pallets, some with thick tongues, and some who simply seemed troubled by having a bit in their mouth. In each case, there was a notable positive difference within minutes of the bit going in the horse’s mouth. In one case, one of our student instructors had been riding a horse for over a year and was unable to get the horse to settle. The mare was extremely agitated all the time, and it didn’t matter if she was in a bit (of any kind) a bosal, halter, or whatever. We tried the prototype of the Raised Snaffle on her and she immediately dropped her head, relaxed, and went to work as if there had never been an issue in the first place.
This is pretty typical of the response we are seeing with the vast majority of horses we have tried the bit on to date. Differences
Snaffle bits all operate relatively the same way in a horse’s mouth. In short, the mouthpiece usually points toward the top (roof) of the horse’s mouth and slightly forward, toward the horse’s front teeth. When pressure is applied to the reins, the mouthpiece “breaks”, creating a sort of nutcracker effect in the horse’s mouth and exaggerates the upward/forward movement of the mouthpiece.
The Rocking S Raised snaffle operates in a completely opposite manner inside the horse’s mouth. As mentioned earlier, the three-piece mouthpiece is ported. It also lies back in the horse’s mouth, toward the molars, instead of forward, toward the horse’s front teeth. In addition, the mouthpiece lies relatively flat on the tongue. With this design, instead of the bit closing down and acting like a nutcracker when pressure is applied to the reins, the mouthpiece actually opens up in the horse’s mouth relieving pressure on the inside. It seems to be this part of the design that is popular with the horses we’ve tried it on. The vast majority of horses we’ve tried the bit on are immediately softer, quieter, and more willing. Another benefit we’ve noticed is this allows the softness in the rider to come out as well.
The only downside to this bit that we’ve seen so far is most horses do mouth it more than normal for the first 15 minutes to an hour or so before they quiet down. I attribute this to the fact that the bit sits in the mouth in a completely different way than any other bit on the market. As such it has a different feel in the mouth, which I don’t necessarily see as a bad thing. Part of what training is about is breaking old patterns, and that is something this bit appears to do in a very quick manner.
To date, we have tried this bit on about 100 horses and have seen dramatically positive differences in all but about three. Of those three, two showed only a slight difference and in one there was no difference at all.
So again, we are not touting this bit as an end-all to training issues, and we are not saying it will work as described on every horse. However, it does seem to be helpful to the vast majority we have tried it on so far. Please click here to go to our shopping cart to purchase a Rockin’ S Snaffle.